E-FAST car emergency jump starter power supply, battery boost device, emergency rescue power bank

Description

\ \ 本店所有商品均为全英文外贸产品，产品链接仅供外贸拿样买货，出口产品，中国大陆不可使用，国内用户请到天猫购买!谢谢! 注意：夹子不能夹反，红色夹子夹电瓶正极，黑色夹子夹电瓶负极，其次，不要连续启动车子，中间要间隔3分钟左右！ \ \ \ \ \ Use tips! (All charging treasures can refer to) The product has just been received. First turn on the flashlight to discharge, then charge the product for more than 4 hours, and then start the car, because the product contains virtual electricity This operation can prolong the service life of the product! Tips for daily maintenance: 1: The battery has a shelf life. Whether you use it or not, it is recommended to charge and discharge the battery once every 2-3 months. 2 When it is not used for a long time! Please keep 3 grids of power supply or more than 50% of power! (Tips: Remember to charge the battery once every 2-3 months when you are not using it. If the power supply is low or the storage of virtual power has an impact on the battery, proper maintenance will last longer~~ Before use, there is a small prompt [1] that the car cannot be started by continuous ignition/or the key cannot be turned, and the positive and negative poles of [2] can not be reversed after every 30 seconds of starting. The two clips cannot be short circuited. [3] Remove the clip within 30 seconds after successfully starting the car. Violation of the above three operations may cause the [fuse box] of the clip to burn out. Please pay attention to the operation method. Feature: Stable voltage, current, balance charge function. Class A+ cell, safe and explosion protective. Upgrade 4 cell and start strongly. 1000A Starting current. 2000A Peak current. 20000mAh Large Capacity. Diesel 3.0L, gasoline 5.0L car can be used. Reverse connection protection. 2 USB charging. Full power can be started 40 times. Limit temperature -20 ~ 60°C. Intelligent Protection System. Input: 5V-2.4A Output: 5V-2.4A*2; 12V Jump Start Night emergency, Rescue lighting: 1. Built-in glare lighting system. 2.Long press the middle button for 3 seconds.Press again in burst mode. 3. After turning on the flashlight,press the switch again to become a flash,the switch is the distress mode. Note: When using the product, you should first turn on the flashlight to discharge, and then charge the product for more than 4 hours before starting the car, because the product contains virtual electricity This can prolong the service life of the product \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \

Specifications